Pages

2011-12-04

Wear-resistant ceramic adhesive rubber liner applied

Wear-resistant ceramic paste should be used in the rubber lining of BD series rubber - metal bonding agent, such adhesive is dedicated to rubber and metal bonding. Appearance is generally brown or brown-yellow viscous liquid, metal - rubber peel strength should be ≥ 60N/2.5cm..
Methods of operation: http://www.prmindustry.com/

Abstract...Articles section 1: rubber playing surface with a wire brush hair, exposing the metal surface grinder grinding fresh substrate, and wash with detergent

(2) the BD series rubber - metal bonding agent after treatment agent C-component mix and dry brush on the metal surface

3 the BD series rubber - metal adhesive agent A main component and curing agent Part B mixed at 8:1, the use of brush on the surface of the metal and rubber, respectively, brushing, drying seems to stick to non-stick, and then the second time in two surface brushing glue and dry sense of home to viscous forces (the back of the hand contact with glue, sticky non-sticky feel like when) the rubber can be bonded to the metal surface, then use the rubber hammer tap from the middle to the surrounding compacted.

4 cure 48 hours at room temperature for maximum strength. Slower type of adhesive curing, curing at least 4 hours to be put into operation.

Note:

1 using the BD series rubber - metal adhesive agent C group before treatment, should stir the bottom sediments using

2. BD series rubber - metal adhesive with solvents, flammable, storage and use should pay attention to ventilation, fire 3.BD series rubber - metal bonding agent should be with the distribution with the use of plastic tie should be in 1 hour run out, not a long time.

4 rubber liner, such as warping powerful, there will be bounce phenomenon after compaction should be split into small pieces in advance liner adhesive.


http://www.prmindustry.com/
     Peter  Huang

No comments:

Post a Comment