1, the conveyor belt in the transport and storage, should be kept clean, avoid direct sunlight or rain and snow soaked leaching, acid-base oils prevent contact with organic solvents and other substances, and 1 m from the heating device.
2, storage temperature should be maintained when the warehouse -18-40 degrees, relative humidity should be maintained at between 50-80%.
3, during storage, the product must be placed into a roll, not fold, flip each quarter should be placed during the time. http://www.prmindustry.com/
Abstract...Articles section 4 different types, specifications should not be connected together layers of conveyor belt use, the connector is best to use bonding method.
5, the conveyor belt of the type, structure, conditions of use should be based on a reasonable number of layers used.
6, the conveyor belt speed should not be greater than 2.5 m / s, fragmentation, wear resistance of materials to be used large fixed power type discharge device, should maximize the use of low speed.
7, transport of the conveyor belt drive pulley diameter and the relationship between the fabric layers, drive pulley, bend pulley and the bracket supporting the request should be based on angle conveyor design requirements, a reasonable selection.
8, the feed direction should conform to the tape running direction, in order to reduce the material impact of the whereabouts of the tape should be used chute, reducing the material fall distance; tape should be reduced by feeding section roller spacing and the use of the buffer roller, to prevent leakage material, with the side of the block should be used moderately soft plate, so as not to block plate mark, scratch the surface of the conveyor belt.
9, the conveyor belt in the course should note the following:
① avoid roller rotation is not working caused by the material covered to prevent leakage of material between the card and the drum and the tape, pay attention to the lubrication of moving parts, but not oil belt;
② Avoid starting with a load;
③ tape deviation occurs, should take timely corrective action;
④ found tape shall promptly repair partially damaged, so as not to expand.
http://www.prmindustry.com/
Peter Huang
PRM Industry is a highly professional Plastic, Rubber and Metal product manufacturing group. We specialize in providing our customers the integrated solutions of plastic, rubber and metal products. With more than 30 years manufacturing experience, we have been doing, and we also own the capabilities to do, is listening to what our customers need and supplying them the best solutions.
No comments:
Post a Comment